| SIMATIC DP, ELECTRON. MODULE F. ET200S, 4 F-DO PROFISAFE, DC 24V/2A, 30 MM WIDTH UP TO CATEGORY 4 (EN954-1) ALSO USEABLE IN PROFINET- NETWORKS WITH IM151-3 HF |
| Supply voltage |
| Load voltage L+ |
| Rated value (DC) | 24 V |
| Reverse polarity protection | No |
| Input current |
| from load voltage L+ (without load), max. | typ. 100 mA |
| from backplane bus 3.3 V DC, max. | 28 mA |
| Power losses |
| Power loss, typ. | 3.5 W |
| Digital outputs |
| Number/binary outputs | 4 |
| Functionality/short-circuit strength | Yes; Electronic |
| Limitation of inductive shutdown voltage to | Typ. (2L+) -47 V |
| Lamp load, max. | 10 W |
| Controlling a digital input | No |
| Output voltage |
| for signal "1", min. | L+ (-2,0 V), current sourcing switch: L+ (-1,5 V), voltage drop on current sinking switch: max. 0.5 V |
| Output current |
| for signal "1" rated value | 2 A |
| for signal "1" permissible range for 0 to 60 °C, min. | 20 mA |
| for signal "1" permissible range for 0 to 60 °C, max. | 2.4 A |
| for signal "0" residual current, max. | 0.5 mA; Current-sourcing: max. 0.5 mA; Current sinking: max. 4 mA |
| Parallel switching of 2 outputs |
| for increased power | No |
| for redundant control of a load | No |
| Switching frequency |
| with resistive load, max. | 30 Hz |
| with inductive load, max. | 0.1 Hz |
| on lamp load, max. | 10 Hz |
| Aggregate current of outputs (per group) |
| horizontal installation |
| up to 40 °C, max. | 6 A |
| up to 55 °C, max. | 5 A |
| up to 60 °C, max. | 4 A |
| vertical installation |
| up to 40 °C, max. | 4 A |
| Load resistance range |
| lower limit | 12 Ω |
| upper limit | 1 kΩ |
| Cable length |
| Cable length, shielded, max. | 200 m |
| Cable length unshielded, max. | 200 m |
| Interrupts/diagnostics/status information |
| Diagnoses |
| Diagnostic functions | Yes |
| Wire break | Yes |
| Short circuit | Yes |
| Diagnostics indication LED |
| Group error SF (red) | Yes |
| Status indicator digital output (green) | Yes |
| Galvanic isolation |
| Galvanic isolation digital outputs |
| between the channels | No |
| between the channels and the backplane bus | Yes |
| between the channels and the load voltage L+ | No |
| Isolation |
| Isolation checked with | 500 V DC |
| tested with |
| Channels against backplane bus and load voltage L+ | 1500 V AC |
| Standards, approvals, certificates |
| Highest safety class achievable in safety mode |
| acc. to EN 954 | Cat. 4 |
| acc. to IEC 61508 | SIL 3 |
| Dimensions |
| Width | 30 mm |
| Height | 81 mm |
| Depth | 52 mm |
| Weight |
| Weight, approx. | 85 g |
