| SITOP POWER 15 V DUAL OUTPUT STABILIZED POWER SUPPLY INPUT: 120-230 V AC OUTPUT: 2X 15 V DC/3.5 A |
| Technical specifications | |
| Product | SITOP dual |
| Power supply, type | 2 x 15 V/3.5 A |
| Input | |
| Input | 1-phase AC |
| Rated voltage value Vin rated | 120 V…230 V |
| Voltage range | 93 V…264 V |
| Wide-range input | Yes |
| Overvoltage resistance | Surge voltage in accordance with EN 61000-6-2 Table 4 |
| Mains buffering at Iout rated, min. | 10 ms |
| Mains buffering | at Vin = 120 V, 40 ms at Vin = 187 V |
| Rated line frequency | 50 Hz/60 Hz |
| Rated line range | 63 Hz...47 Hz |
| Input current / at nominal level of the input voltage 120 V | 1.9 A |
| Input current / at nominal level of the input voltage 230 V | 1.15 A |
| Switch-on current limiting (+25 °C), max. | 30 A |
| Duration of current limiting / at 25 °C / typical | 3 ms |
| I²t, max. | 3 A²·s |
| Built-in incoming fuse | T 4 A/250 V (not accessible) |
| Protection in the mains power input (IEC 898) | Recommended miniature circuit breaker: from 10 A, characteristic C, or from 16 A, characteristic B |
| Output | |
| Output | controlled, isolated DC voltage |
| Rated voltage Vout DC | 15 V |
| Output voltage | 2 x 15 V DC |
| Output voltage / at the output 1 / for DC / nominal value | 15 V |
| Output voltage / at the output 2 / for DC / nominal value | 15 V |
| Total tolerance, static ± | 2 % |
| Static mains compensation, approx. | 0.2 % |
| Static load balancing, approx. | 0.2 % |
| Residual ripple peak-peak, max. | 50 mV |
| Residual ripple peak-peak, typ. | 20 mV |
| Spikes peak-peak, max. (bandwidth: 20 MHz) | 150 mV |
| Adjustment range | 14.5 V…17 V |
| Product feature / output voltage adjustable | Yes |
| Output voltage setting | via potentiometer |
| Status display | Green LED grün for Vout >10 V (summation display) |
| Signaling | - |
| On/off behavior | Overshoot of Vout < 3 % |
| Startup delay, max. | 1 s |
| Rated current value Iout rated | 3.5 A |
| Output current / at the output 1 / nominal value | 3.5 A |
| Output current / at the output 2 / nominal value | 3.5 A |
| Current range | 0 A…3.5 A |
| 2 x 0 ... 3.5 A up to +45 °C |
| delivered active power / typ. | 105 W |
| Parallel switching for enhanced performance | Yes |
| Numbers of parallel switchable units for enhanced performance | 2 |
| Efficiency | |
| Efficiency at Vout rated, Iout rated, approx. | 80 % |
| Power loss at Vout rated, Iout rated, approx. | 27 W |
| Closed-loop control | |
| Protection and monitoring | |
| Output overvoltage protection | according to EN 60950 |
| Current limitation | 4.9 A |
| Design of the current limitation | Limit point < 4.9 A; switch-off point < 6 A |
| Characteristic feature of the output / short-circuit protected | Yes |
| Short-circuit protection | Electronic shutdown, automatic restart |
| Overload/short-circuit indicator | - |
| Safety | |
| Primary/secondary isolation | Yes |
| Potential separation | Safety extra low output voltage Vout according to EN 60950-1 |
| Protection class | Class I |
| stray current / maximum | 3.5 mA |
| CE mark | Yes |
| UL/CSA approval | Yes |
| UL/cUL (CSA) approval | cULus-Listed (UL 508, CSA C22.2 No. 142), File E179336 |
| Explosion protection | - |
| FM approval | - |
| CB approval | No |
| Verification of suitability / C-Tick | No |
| Marine approval | - |
| Degree of protection (EN 60529) | IP20 |
| EMC | |
| Emitted interference | EN 55011 Class A |
| Supply harmonics limitation | - |
| Noise immunity | EN 61000-6-2 |
| Operating data | |
| Ambient temperature / in operation | 0 °C…60 °C |
| with natural convection |
| Ambient temparature / on transport | -40 °C…70 °C |
| Ambient temparature / in storage | -40 °C…70 °C |
| Humidity class according to EN 60721 | Climate class 3K3, no condensation |
| Mechanics | |
| Connection technology | screw-type terminals |
| Connections / Supply input | L1, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm² single-core/finely stranded |
| Connections / Output | P15_1, GND_1, GND_2: 1 screw terminal each for 0.5 ... 2.5 mm²; P15_2: 2 screw terminals for 0.5 ... 2.5 mm² |
| Connections / Auxiliary | - |
| Width / of the housing | 75 mm |
| Height / of the housing | 125 mm |
| Depth / of the housing | 125 mm |
| Installation width | 75 mm |
| Mounting height | 325 mm |
| Weight, approx. | 0.75 kg |
| Product feature / of the housing / housing for side-by-side mounting | Yes |
| Type of mounting / wall mounting | No |
| Type of fixing / cap rail mounting | Yes |
| Type of mounting / S7-300 rail mounting | No |
| Installation | Snaps onto DIN rail EN 60715 35x7.5/15 |
| Last change: | Sep 21, 2011 |
